Rubber Tree Plantation

File:Sad Steve.png

ATTENTION!
This article contains material that is not in the current version of Tekkit.
The content you see here is not available if you are using the current version.

When you place a Rubber Tree Plantation, it will start to clear out the farm area. The farm area currently is a hollow column with a dimension 13x13x10 (X-Y-Z) blocks and 3 blocks wide with the Rubber Tree Plantation itself at the center of the ground level. Completely ignores the center 7x7 area in the middle. It will idle until it receives the right materials to start the farm. You will need to supply it with Humus and Saplings. Both materials can be either placed directly into its storage or be supplied by BuildCraft Pipes. After receiving Humus it will lay down the soil. When this is finished, it will start to plant saplings. The Rubber Tree Plantation will replace any missing sapling and any degraded soil. If it cannot replace degraded soil because of a lack of Humus, it will also stop planting trees.

When replacing a block of soil, the Rubber Tree Plantation tries to store the sand in its inventory. Only if the inventory for sand is full will it silently discard the block. Sand will also be ejected automatically into connected Buildcraft Pipes. Its inventory is partitioned into three sections for Humus, saplings and (collected) sand. The Rubber Tree Plantation will refuse items other than Humus and Saplings from pipes. Items can be inserted by pipes on any side and sand is ejected to pipes connected to any side. After the slots for Humus or saplings are filled, the Rubber Tree Plantation will refuse the oversupplied item, even if there are still slots for the other item type.