Plate Bending Machine
| Plate Bending Machine | |
|---|---|
| Name | Plate Bending Machine |
| Type | Machine |
| Physics | No |
| Transparency | No |
| Luminance | No |
| Tool | ic2wrench |
| Stackable | Yes (64) |
| Data Value | 702:59 |
| Mod Included | GregTech |
The Plate Bending Machine is a Machine added by GregTech, and is used to make Ingots into their corresponding plates for use in various GregTech recipes and Plates into Standard Rails. It uses only Low Voltage EU, so if it is supplied more than 32EU/p it will explode.
- With the inclusion of the Conveyor Module, the Plate Bending Machine will automatically output completed product. Items can only be output to inventories that are attached to the output side. Automatic output is triggered once per minute or if both output slots are full. Automatic output can be disabled by pressing the orange conveyor button.
- EU is also transferred to the output side if the EU transfer button is pressed.
- Center slot will accept batteries as a power source.
- Will not accept power or items from the front side.
- You can switch between separated and unseparated Input Slots by pressing the "bar" button.
- If there are too many overclocker upgrades the machine will not output an item at all.
GregTech automations are not compatible with pipes or tubes. An attached inventory must be used like a chest or the Red Power Relay.
Recipe
Usage
The following plates may be created using their corresponding ingot:
Template:Grid2Template:Grid2Template:Grid2Template:Grid2Template:Grid2Template:Grid2Template:Grid2Template:Grid2Template:Grid2Template:Grid2Template:Grid2Template:Grid2Template:Grid2Template:Grid2Template:Grid2Template:Grid2Template:Grid2Template:Grid2Template:Grid2Template:Grid2Template:Grid2
If Railcraft is installed, Tin, Iron and Steel Plates are changed to the Railcraft ones.
To set the output side of the machine, allowing the machine to output to adjacent chests, take an IC2 wrench and right click on any side. This will set the OPPOSITE side to the output side.
